Ardis Bazyn — 818-238-9321 — firstname.lastname@example.org '
Go Directly to Page Text
About Ardis Bazyn
One Sheet (PDF)
Testimonials & References
Resume & Skills
Photos and videos of
Subscribeto Make the Impossible Possible
Newsletter Mailing List
Your email address is private and
will not be shared with anyone else
SIMPLIFIED PARLIAMENTARY PROCEDURE
Parliamentary procedure is a system of rules that allow members to know what they can expect from each other in an orderly, fair, and efficient way. The procedures are based on two universally accepted democratic principles, which balance the interests of the individual and of the group. Every member has equal rights and obligations. The officers and members must deal with each other in good faith and with fairness. The whole organization is undermined to the extent that any individual or minority is not treated equally. The majority rules. Assured of fairness for all, and recognizing that unanimity is impossible, each member agrees in advance to accept the will of the majority in order to facilitate decision making. This is, in effect, an unqualified grant of trust and confidence. All the procedures summarized below are an application of these principles. They allow members to express their opinions, act on their needs, and know what is going on.
After the president or chair opens the meeting, members wishing to have the floor (ask to speak on any subject or motion) must request to speak. You say, "Mr. or Madame President or Chair, may I have the floor?" The president or chair will respond by allowing you to speak or letting you know when you can speak. The president or chair may list the order of speakers if several have asked to speak at the same time.
A motion is the formal proposal of a suggestion for consideration of the group. A motion gives the group something to react to and act on so that there can be a final decision. A motion limits discussion to something definite so that everyone knows what is at stake and what the outcome will be. To make a motion, a member says, "I move that ____." A second is required and indicates that at least two people feel that the proposal merits consideration. If a second is not given, the item is not discussed, simply because it doesn't have enough support to be considered. To second a motion, a member says, "I second that motion."
Amendments are suggested changes to a motion before the body. They must be germane (which means they must have something to do with the motion being discussed). There can even be an amendment to an amendment, but that's all. Amendments have to be seconded. Once before the group, discussion is limited to the amendment in question. The group votes on the last amendment proposed and works its way back to the main motion. To amend a motion, a member says, "I move to amend the motion by ____."
Motions are prioritized chronologically. Motions are passed in order of precedence. In other words, if a motion is being discussed, you can interrupt that discussion to present a new motion. It must either be an amendment to the motion under discussion or a motion concerning the current motion. If it is regarding another matter or would only b possible if the current motion under discussion passes, you have to wait until the discussion is complete and the motion is voted upon. Otherwise, the new motion is "out of order" and the chair will indicate by saying "Out of order".
Withdraw a Motion when you have made a motion and want to withdraw it, which simply means you have changed your mind. You say, "I withdraw my motion," and that's it unless discussion has started on your motion. Then it is the property of the body and can only be withdrawn by a motion to permit withdrawal, which requires a second, is neither debatable nor amendable, and requires a majority vote. Of course, if no one objects, a motion may be withdrawn at any time. Division of the Question may be called when you want to consider a motion point by point. You say, "I request the motion be divided as follows ____." If the chairman agrees, debate and voting will be conducted on each point, one at a time. If the request is not granted, you may move to divide the question. The rules applying to main motions govern this action.
Division of the Assembly is called when the results of a vote are unclear or you want a definite count taken instead of a voice vote. You say, "I call for a division of the assembly." You may state if you want a hand count, secret ballot, or roll call vote. If there is a conflict, the chairperson will decide the method of vote. It is common for someone to simply ask for a roll call vote.
End Debate when you want to end debate and put the question being discussed to an immediate vote. You say, "I move we end debate." The motion requires a second, is not debatable, is not amendable, and requires a 2/3 vote. If there is more than one part of the proposal being discussed, i.e., there are amendments, or other motions to refer to a committee, or to postpone, etc., you should specify whether you are moving for a vote on the item under immediate consideration or on all matters pertaining to that question. If there is no objection, the chairman may end debate on his own or at the suggestion of a member. However, if there is an objection from any member, a motion is required to end debate. In many meetings, the phrase "I would like to call the question" is often used instead of a move to end debate. The difference between calling the question and ending debate is that calling the question is considered a vote of acclimation. In other words, no vote is necessary unless there are objections to ending debate.
Limit Debate when you want to limit debate to a certain amount of time or to a certain number of additional speakers. You say, "I move we limit debate to ____ [a specified number of speakers on each side or a specific time]." If there is more than one part to the proposal being considered, you should specify whether you want to limit debate to just one item under discussion or to all discussion on the main question. The motion requires a second, is not debatable, and requires a 2/3 vote. (The same special restrictions for the motion to end debate hold for the motion to limit debate.)
Refer to a Committee when you want to have a smaller group go over what is being discussed before further action. You say, "I move we refer this matter to ____." The motion requires a second, is debatable and amendable only as to which committee will handle the matter, and requires a majority vote. Business may be referred to an existing group, such as executive committee, or to an ad hoc committee, which is a committee especially established for a specific purpose and exists until the matter is resolved; or to the committee of the whole (which is a way of saying that the group can consider the matter informally). Usually a matter is referred to the committee of the whole when there is need to discuss a matter before the introduction of a motion. The same effect can be achieved by moving to consider the matter informally or by moving to table the discussion until another time.
Appeal when you want to reverse a decision or ruling of the chairman. You say, "I appeal the decision of the chair (stating the action or decision that is objected to)." This appeal requires a second. The chairperson may explain his or her reason for decision without leaving the chair. The appeal is debatable, is not amendable, and requires a majority vote to overrule the chair. The appeal must be made immediately after the decision in question. The chair must recognize all appeals. When you want to end the meeting, you say, "I move we adjourn." The motion requires a second, is not debatable, and must be put to an immediate vote. It requires a majority vote for passage. Adjournment ends the meeting. Any unfinished business is then considered old business at the next meeting. Recess when you want to suspend the meeting, take a break, or just hold off until a specific time before the next regular meeting. "I move we recess until ____." The motion requires a second, is debatable only as to the time of the resumption of the meeting, and requires a majority vote. The only acceptable amendment is on the time of the resumption of the meeting. Dilatory behavior is behavior that is made in a deliberate attempt to delay the body. Frivolous behavior is behavior that is just plain silly
A quorum is simply the number of members required for a vote. For most board meetings, this requires one more than half of the members to be present for any actions to be taken. However, in conventions, the number varies according to the organization constitution.
For Positive inspiration, contact Bazyn Communications!
"Making the Impossible Possible"
This web site is